IT Network Equipment Supplier
Buy a non-standard POE power supply switch or a standard POE power supply switch. This mainly depends on whether the AP and IP Camera to be powered supports 48V, 24V or 12V input? If it is 48V, it says that it supports IEEE802.3 AT or AF power supply standards, which are generally standard. If it is a 24V and 12V power receiving device, you need to find the corresponding 12/24V non-standard power supply switch, and you can also buy a standard one. At this time, you need to buy a PD power receiving separator to convert the POE into DC power supply and network cable data.
Then why is it still more recommended that we buy the standard one, because there are many risks involved!
The working principle of a non-standard POE power supply switch is classified as a switching power supply, without a POE chip, only through a transformer to step down 220V AC to 48V DC, without detecting the lower-end power-receiving equipment, directly output voltage and current at each RJ45 port without interruption, which may cause the voltage to be too high and burn out the lower-end power-receiving equipment. Such equipment cannot be directly connected to other network equipment, because the direct connection simply leads to 2 pairs of network cables in the POE power supply, and the positive and negative electrodes are connected to form a short circuit. At light, the port is damaged, and at worst, it will smoke and catch fire, which will briefly pose the risk of an accident.