Intelligent It Solutions 's Sitemap

Products

Posts

Does the switch support Power over Ethernet?
Do I need 10 gigabit and multi-gigabit Ethernet speed?
What’s the difference between Cisco Business 250 and 220 series smart switches?
What’s the difference between managed, smart, and unmanaged switches?
What is a switch vs a router?
What is Network Descriptor Block (NDB)?
What is the significance of Time mentioned in the routing table entry?
What does the term threshold and timeout in IP SLA operation mean?
How is accounting data age calculated?
How do you limit the number of sessions when a customer accesses the network?
Can you configure different MTU for subinterfaces under the same main interface? How do 7500/GSR/ESR routers behave in this scenario?
What is the difference between point-to-point subinterfaces and multi-point subinterfaces?
What is the purpose of ports 2228 and 56506?
What is the difference between the two methods to create static routes?
How do I connect two different ISPs and route different traffic to different ISPs?
What is Virtual Routing and Forwarding (VRF)?
Can a VLAN interface and a tunnel interface have the same IP address?
What is the Pause control counter?
What are the maximum number of secondary IP addesses that can be configured on a router interface?
Who does load-balancing when there are multiple links to a destination, Cisco Express Forwarding (CEF), or the routing protocol?
What is Unicast Reverse Path Forwarding (uRPF)? Can a default route 0.0.0.0/0 be used to perform a uRPF check?
I have four equal cost parallel paths to the same destination. I am doing fast switching on two links and process switching on the other two. How will the packets be routed in this situation?
Is there a performance advantage when using the the IP access list keyword established on an extended ACL? Does using “established” make the access list more vulnerable? Do you have specific examples of the usage?
I have primary and secondary IP addresses configured on an Ethernet interface and my router is running RIP (a distance vector routing protocol). How does split-horizon affect the routing updates?
Is it possible to have duplicate ip addresses for two serial interfaces that belong to the same router?
Can I configure two interfaces in the same subnet (t0 = 142.10.46.250/24 and t1 142.10.46.251/24)?
Can an interface have more than one ip access-group statement in its configuration?
Would it be possible to configure a router for a 255.255.254.0 Ethernet and a 255.255.252.0 serial subnet? Does IGRP/RIPv1 support variable subnetting?
Does the interface subcommand no arp arpa disable the Address Resolution Protocol (ARP) function for a router interface?
Does the use of extended IP access control lists (ACLs) filter regular routing updates (such as OSPF)? Do I need to explicitly permit the multicast IPs used by routing protocols (such as 224.0.0.5 and 224.0.0.6, in the case of OSPF) for updates to ensure the proper working of routing protocols?
How do I configure my router to prefer an Open Shortest Path First (OSPF) route over an EIGRP route when the route is learned from both sources?
Enhanced Interior Gateway Routing Protocol (EIGRP) redistributes with the IGRP IP routing protocol automatically. Does EIGRP also interact with the Routing Information Protocol (RIP) IP routing protocol?
How do I use the ip helper-address command to forward Bootstrap Protocol (BOOTP) frames?
What does route summarization mean?
What is the difference between the ip default-gateway, ip default-network, and ip route 0.0.0.0/0 commands?
When does a Cisco router initiate a routing request out its interfaces?
The 5 Technologies that will Change Networking
When does a Cisco router generate a source quench?
What does route summarization mean?
How is the load shared between two parallel lines of equal capacity when these lines are configured for load balancing?

Go to full version: Intelligent It Solutions